SMT Stapler Splice Tool

SMT stapler splice tool

Usage of this stapler splice tool:

1, press hard to open the two handles of the pliers, so that the lower pressure plate and the bottom plate open, take a piece of copper buckle placed on the two bolts of the copper buckle, pay attention to the correct position of the copper buckle,

2, the two disconnected material belt respectively take a end, respectively move the two card material bars parallel to the bottom plate, and then the disconnected material belt is aligned above the copper buckle, and then card the material belt.

3, hold the two handles with your hand, and use even force to close the two handles until the lower pressure plate and the bottom plate are combined into a level, so that the copper buckle will jam the material belt.

4, finally let the two handles open, unscrew the card bar, take out the connected material belt.

Product advantage:

1, the principle of stapler, convenient and fast;

2, can be quickly installed on the receiving table, saving time;

3, paper tape, material tape all compatible, good expansibility;

4, the copper plate is easy to install, greatly improve efficiency;

5. Fast and accurate feeding.

6, Package is 1pcs/box, use for no side stapler clips